What to do if Furuno Monitor radar goes into stand-by after pressing GAIN/TX key?
If you press the GAIN/TX key to transmit and the "TX screen" appears, but the radar goes into stand-by on your Furuno Monitor, this indicates that the overload protection has activated. To restore normal operation, turn off all equipment in the NavNet network, wait a few seconds, and then turn on all equipment.
What to do if nothing appears on Furuno Monitor display after pressing power and GAIN/TX key?
If nothing appears on the Furuno Monitor display after pressing the power switch and then the GAIN/TX key, ensure you press the key for more than one second. Also, check that the antenna cable is securely fastened and that the radar source is correct.
Why is the picture not updating or freezing on my Furuno Monitor?
If the picture on your Furuno Monitor is not updating or freezes, check the antenna cable. If the picture freezes, try turning the display unit off and on.
How to fix the 'position not fixed' error on Furuno Monitor?
If the position is not fixed on your Furuno Monitor, check that the antenna connector is fastened and the navigator is correctly connected.
Why do marks and legends appear but no echoes on Furuno Monitor?
If marks and legends appear on your Furuno Monitor, but echoes do not, check that the antenna cable is securely fastened.
How to turn on vessel track on Furuno Monitor?
If the track of your vessel is not being plotted on the Furuno Monitor, check that the track is turned on. To do this, put the cursor on the boat icon to open the pop-up menu and check that "Tracks" is on.
What to do if there is no response when a key is pressed on Furuno Monitor?
Turn off and on the power. If you do not get a response, the key is damaged. Contact your dealer for instructions.
Why does depth indication not appear on Furuno Monitor?
For manual operation, adjust gain and range to display the bottom echo (in reddish-brown). Adjust bottom level HF/LF (Menu?System?DFF(ETR).
Why is the water temperature data incorrect on my Furuno Monitor?
If the water temperature graph appears on the Furuno Monitor, but the data is incorrect, check that the sensor cable is securely fastened.
Why is the picture sensitivity too low on my Furuno Monitor?
If the picture sensitivity on your Furuno Monitor is too low, check the gain setting in manual operation. Marine life or air bubbles attaching to the transducer face can also cause this issue, as can a bottom that is too soft to return an acceptable echo.
General| Display Size | 12.1 inches |
|---|---|
| Brightness | 1000 cd/m² |
| Touchscreen | Yes |
| Power Supply | 12-24 V DC |
| Operating Temperature Range | -15°C to +55°C |
| Input Voltage | 12-24 V DC |
| Display Type | LCD |
| Resolution | 800 x 600 |
| Storage Temperature | -20°C to +70°C |
To Next Page
