Furuno MFD12 - Data Boxes

1. System Introduction
1-15
1.14 Data Boxes
The data boxes show the navigation data. You can select the data to display in the
boxes, and show or hide the boxes as necessary. A box can show one or more data.
Multiple data are scrolled according to the scrolling time set on the [DataBox] menu.
The data that you can show depends on your system configuration. You can show a
maximum of five boxes, four at the bottom-left corner and the cursor data box at the
top-right corner. The no. 4 data box only appears if a destination is set.
To alternately hide and show the boxes, use the DATA/VOL key.
You can select the data to display in the boxes on the screen, or from the [Data Box
]menu. For additional information, see the section "13.2 Data Boxes”.
To change the contents of a data box:
1. Put the cursor in a data box (the box is blue if cor-
rectly selected). Hit the right-click button to
show the Data Box pop-up menu.
2. Rotate the RotoKey to select the data item to
show or hide.
3. Push the RotoKey to hide or show the item and
close the pop-up menu.
SOG
kt
COG
°
T
23.2
6.2
98.7
DPT
m
1 2 3
Data box location Sample data boxes (lower left corner)
4
Cursor data box
Data boxes 1-4