Furuno MFD12 - How to Replay a Saved Track; How to Remove a Replayed Track

2. Chart Plotter
2-22
4. Use the RotoKey to enter name. Rotate the key to select a character then push
the key to validate your selection. You can use a maximum of eight characters for
the name. (To save the track under the name shown in the [Rename] box, push
the RotoKey continuously until the box closes. Use the RotoKey to push the OK
button.)
5. Press the MENU key to close the menu.
2.11.7 How to Replay a Saved Track
You can replay saved track on the display to use the track to create a route. The saved
track appears with the current track. If the screen is full of active track, clear the active
track before you replay the saved track to prevent clutter.
1. Press the MENU key to open the menu.
2. Open the [Ship & Track] menu.
3. Use the RotoKey to select [Open Saved Track]. The saved track list appears, an
example of which is shown below.
4. Use the RotoKey to select the track to replay.
5. Press the MENU key to close the menu and replay the track.
2.11.8 How to Remove a Replayed Track
After you have used a replayed track, you can remove the track from the screen as
follows:
1. Press the MENU key to open the menu.
2. Open the [Ship & Track] menu.
3. Use the RotoKey to select [Close Saved Track].
4. Press the MENU key to close the menu.
FISH1
LOBSTER
CRAB
HOME