4. Points
4-13
4.11.2 How to go to Cursor Position
The benefit of using the cursor position is you do not have to use a saved point. The
point is erased when the navigation is cancelled.
GO TO/LIST key
Put the cursor on the location then push the GO TO/LIST key.
Pop-up menu
Put the cursor on the location then push the right-click button to show the Cursor Po-
sition pop-up menu. Use the RotoKey to select [Go To] or [Go To by Position]. To set
the position accurately, use [Go To by Position]. Set the position in the [Validate Po-
sition] box with the RotoKey. Push the key to select the location in the box, rotate the
key to set value, then push the key to validate the position.
Validate position window (position input)
Cursor position pop-up menu
Go To
Go To by Position
New Point
New Route
Center on Boat
To Next Page
Loading...
Need help?
General
