Furuno MFD12 - How to Go to a Point Selected from the Points List; How to Extend a Route Made with a Single Point

4. Points
4-15
4.11.3 How to go to a Point Selected from the Points List
1. Long-push the GO TO/LIST key to open the [Points] menu then open the Alpha
list.
2. Use the RotoKey to select a point.
3. Push the RotoKey to show the [Points] Menu pop-up. The cursor selects [Go To].
Push the RotoKey.
The menu is erased and the chart plotter display appears. A red dashed line runs be-
tween current position and the point. This line is the course to follow to get to the point.
The point arrival area is indicated with a circle, or both circle and line. You can select
the arrival area indication method with [Waypoint Switching Mode] in the [Routes-
General] menu. To receive an aural alarm when you are within a preset distance, turn
on [Waypoint Notification] and set [Switching Circle Radius] on the [Routes-General]
menu. The XTE alarm lines, red for port side, green for starboard side, show the XTE
alarm range. You can show or hide these lines with [XTE Alarm Lines] in the [Routes-
General] menu.
4.11.4 How to Extend a Route Made with a Single Point
If you have made a route with a single point and you need to go other locations, you
can easily extend the route as follows.
1. Use the CursorPad to put the cursor on the dashed line of the route.
2. Push the right-click button to show the Route Follow pop-up menu.
3. Use the RotoKey to select [Extend Route].
4. Set the cursor on a new location and push the left-click button.
5. Repeat step 4 to add additional points.
6. Push the RotoKey to finish.
New Point
Edit
Delete
Find on Map