Furuno MFD12 - Facsimile Receiver FAX-30

1. System Introduction
1-23
1.19 Facsimile Receiver FAX-30
The FURUNO Facsimile Receiver FAX-30 installs in the NavNet network and can be
controlled from a NavNet display. Below are the steps to start fax operation.
1. At installation of this equipment, connect the FAX-30 to the NavNet and check that
the equipment identifies the FAX-30, through the Installation Wizard.
2. Select the "full screen" FAX display. For the procedure, refer to the section "13.3
How to Set the Display Selection Window". The fax display is available only in the
full-screen display.
3. To operate the FAX-30, use the DISP key to select the fax display icon to show
the fax display. A sample display is shown below. Refer to the Operator’s Manual
of the FAX-30 for operation information.
Use the CursorPad or a PC mouse to operate the fax screens.
The FAX-30 display can be accessed only by one NavNet display. When another Nav-
Net display accesses the FAX-30, control of the FAX-30 is given to that display after
the picture is stopped completely. This sequence takes approximately one minute.