Furuno MFD12 - Page 37

1. System Introduction
1-22
MOB information
There are two types of MOB information, simple and detailed. Simple information in-
cludes point name (MOB), and range and bearing to the MOB position. Detailed infor-
mation includes simple information plus the information shown below.
• Comment (default comment is “time of MOB”)
• Depth at MOB position (requires depth sensor)
• Water temperature at MOB position (requires temperature sensor)
• Group name (if any)
• Avoidance circle radius
To get simple information, put the cursor on the MOB mark on the chart plotter display.
For detailed information, put the cursor on the MOB mark and hit the left-click button.
How to erase a MOB mark
You can erase a MOB mark on the chart plotter display, or at the [Points] list in the
[Points] menu.
Not active MOB mark: Put the cursor on the MOB mark and press the right-click but-
ton to show the Points pop-up menu. Use the RotoKey to select [Delete].
Active MOB mark: Before you can erase an active MOB mark, you must cancel nav-
igation. Put the cursor on the MOB mark and press the right-click button to show the
Points pop-up menu. Rotate the RotoKey to select [Cancel Route] then push the Ro-
toKey. Select again the MOB mark, show the Points pop-up menu, and use the Ro-
toKey to select [Delete].
Detailed MOB informationSimple MOB information
244 yd
229.1
°M
Points popup menu
(No route active)
Points popup menu
(Route active)