Furuno MFD12 - How to Set the Cycle Period; How to Show Video ID

9. Camera/Video
9-3
9.2.3 How to Set the Cycle Period
The default cycle period is five seconds. The cycle times of 10 and 30 seconds are
available also.
1. Press the MENU key.
2. Open the [Camera] menu.
3. Use the RotoKey to select [Time Interval].
4. Use the RotoKey to select a time interval.
5. Press the MENU key to close the menu.
9.3 How to Show Video ID
You can show video ID at the top-left corner. Use the RotoKey to select [Video ID]
then push the key to show or hide the video ID.