Furuno MFD12 - How to Erase an EBL; How to Select True or Relative Bearing

6. Radar
6-11
6.8.2 How to Erase an EBL
1. Push the RotoKey to show the soft controls. (In the default arrangement, a short-
push activates EBL1 and a long-push activates EBL1 and EBL2.)
2. Select [EBL] and [Clear1] or [Clear2].
The selected EBL and the related EBL indication are erased.
You can also erase and EBL with the EBL/VRM pop-up menu. Put the cursor in the
EBL box then push the right-click button to show the EBL/VRM pop-up menu. Rotate
the RotoKey to select the EBL then push the key to erase.
6.8.3 How to Select True or Relative Bearing
A "T" (true) follows the EBL indication if the bearing is in reference to the north, or "M"
when [Bearing Display] in the [Global-General] menu is set for [Magnetic]. (There is
no indication for relative bearing.) You can select relative or true bearing indication in
the head-up mode as follows:
1. Press the MENU key to open the menu.
2. Open the [Radar] menu.
3. Use the RotoKey to select [EBL Reference].
4. Use the RotoKey to select [Relative] or [True].
5. Press the MENU key to close the menu.