Furuno MFD12 - How to Mark a Point; How to Mark a Point at Current Position; How to Mark a Point at Cursor Position

4. Points
4-2
4.2 How to Mark a Point
You can mark a point
• At current position
• At cursor position
• From the Points list
4.2.1 How to Mark a Point at Current Position
Press the SAVE/MOB key to mark a point at current position. The following occurs.
• The default point symbol is put at current position.
• The point is saved to the Points list under the youngest empty point number
4.2.2 How to Mark a Point at Cursor Position
POINTS/ROUTES key
Use the CursorPad to put the cursor on a location. Press the POINTS/ROUTE key.
The default point symbol is put at the cursor position. The point is saved to the Points
list and marked with the youngest empty point number.
Pop-up menu
You can also put a point at the cursor position with the Cursor Position pop-up menu,
shown below. Use the RotoKey to select [New Point] then push the key to put a point
at the cursor position.
Go To
Go To by Position
New Point
New Route
Center on Boat