13. How to Adjust Settings
13-9
13.2.2 How to Show or Hide all Data Boxes
You can show or hide all data boxes. Select [DataBox Display] at the bottom of the
[DataBox-General] menu then push the RotoKey to show or hide all data boxes. You
can also hide or show the data boxes with the DATA/VOL key.
13.2.3 How to Adjust Transparency of Data Boxes
You can adjust the degree of transparency for the data boxes with the [Transparency]
slider. The available degree of transparency is 0-80(%). (Alpha blending technology is
used for transparency effects.)
13.3 How to Set the Display Selection Window
Section 1.5 shows how to select a display at the display selection window. The default
display selection window provides five displays, identified as "hotpages," in configura-
tions according to the equipment that you have in your network. If the arrangement of
the hotpages does not meet your requirements, you can change the hotpages as nec-
essary. You can select the number of hotpages to show from five to ten and split a
hotpage up to four ways. For example, you can show the radar and fish finder displays
in a two-way split screen.
You can select how to split a hotpage by four different methods: full-screen, two-way,
three-way and four-way. The displays available depend on the screen division select-
ed and your system configuration. The table below describes screen division and pos-
sible display.
13.3.1 How to Set the Number of Hotpages to Show
Set the number of hotpages to show on the display selection window as follows:
1. Press the MENU key to open the
menu.
2. Open the [My NavNet-General] menu.
3. Use the RotoKey to select [Hotpage
Number].
4. Use the RotoKey to select a number.
5. Press the MENU key to close the
menu.
Screen division Possible display
Full Chart plotter, radar, camera, fish finder, weather facsimile
Two-way split Chart plotter, radar, fish finder
Three-way split Chart plotter, radar, fish finder
Four-way split Chart plotter, radar, camera, fish finder, instrument
To Next Page
Loading...
