Furuno MFD12 - How to Set a Hotpage

13. How to Adjust Settings
13-10
13.3.2 How to Set a Hotpage
This section shows how to set a hotpage. The procedure shown below describes how
to put the radar, chart plotter and fish finder displays in a three-way split screen.
1. Press the DISP key to show the display selection screen.
2. Long-push the RotoKey to show the hotpage arrangement screen, shown below.
3. Rotate the RotoKey to select the three-way split icon at the left-side of the screen
then push the RotoKey. The chart plotter display appears on left-half of the
screen.
4. Rotate the RotoKey to select one of the display icons (for example, the radar dis-
play) at the bottom of the screen. Push the RotoKey.
5. The yellow rectangle moves to the top-right 1/4 of the screen. Rotate the RotoKey
to select a display (for example, the chart plotter display) then push the RotoKey.
Note: To return one step, use the CANCEL key.
Select
display
division.
Select display.
(Display availability depends on display division
and system configuration.)