1. System Introduction
1-11
1.10 The Cursor
The cursor is always displayed on the radar, chart plotter and fish finder displays and
has the functions shown below.
• Find the position, range and bearing to an object on the chart plotter and radar dis-
plays
• Find the depth to an object on the fish finder display.
• Select a position for a waypoint on the chart plotter display.
• Select an item. For example, a waypoint on the chart plotter display.
To move the cursor, press any of the four arrows on the CursorPad to the cursor the
direction indicated on the arrow pressed. You can also move the cursor from one cor-
ner to the opposite corner when you press any two locations together on the Cursor-
Pad. The cursor position and range and bearing from your vessel to the cursor position
are alternately shown in the cursor data box at the upper right corner of the screen.
(The chart plotter and radar displays only).
Cursor position and range and bearing to cursor
On the radar and chart plotter displays the cursor also provides a pop-up menu. For
additional information, see “1.13 Pop-up Menus."
: Inactive
: In motion
Alternately
To Next Page
Loading...
