5. Routes
5-14
5.10.5 Waypoint Switching Mode
When you reach a route point, your unit automatically changes to the next route point
according to the waypoint switching mode selected on the menu.
Cross Line: Change the waypoint when the vessel moves through an imaginary cross
line (vertical line) that moves through the center of the destination point.
Circle: Change the waypoint when the vessel comes within the circle.
Cross Line & Circle: Change the waypoint when one of the above two conditions is
met.
1. Press the MENU key to open the menu.
2. Open the [Routes-General] menu.
3. Use the RotoKey to select [Waypoint Switching Mode].
4. Use the RotoKey to select an option.
5. Use the RotoKey to select [Switching Mode Circle Radius].
6. Use the RotoKey to enter the distance from a route point at which to change to
next point.
7. Press the MENU key to close the menu.
Circle Circle and
Cross Line
Cross Line
Cross Line
Cross
Line
To Next Page
Loading...
