Furuno MFD12 - How to Select a Display

1. System Introduction
1-6
1.5 How to Select a Display
Use the DISP key and the RotoKey to select a display, from the display selection win-
dow. The displays available depend on your system configuration and the HotPage
settings on the [My NavNet] menu. (You can change the display selection window ac-
cording to your needs and system configuration.))
1) Press the DISP key to show the display selection window. (The labels in the illus-
tration below do not appear on the display.)
Display selection window (example)
2) Rotate the RotoKey to put the required display in the "monitor" at the bottom of
the screen.
3) Push the RotoKey to validate your selection.
How to select the active display in combination displays
Use the CTRL key to change the active display in combination displays. A thick yellow
line is around the active display.
COMBINATION DISPLAY
(radar+chart plotter)
RADAR
DISPLAY
FISH
FINDER
DISPLAY
CHART
PLOTTER
DISPLAY
CAMERA
DISPLAY
CTRL
CTRL
ACTIVE
ACTIVE
ACTIVE
ACTIVE