Furuno MFD12 - How to Find Information about an On-Screen Point

4. Points
4-4
3. The cursor is selecting [Total]. Push the RotoKey twice then the right side of the
display shows the point information like in the illustration shown below.
4. If necessary, change the point settings, See the section "4.8 Editing Points on the
Points List" on page 4-11.
5. Use the RotoKey to click the OK button.
6. Press the MENU key to close the menu.
4.3 How to Find Information About an On-screen
Point
Put the cursor on a point. Simple point information (name, and range and bearing from
your vessel) appears. To find detailed information, hit the left-click button. Detailed
information includes simple information plus comment, depth and temperature at time
of entry, group name and avoidance circle area.
Point name, range and bearing
to point and point group name
appear here.
Total no. of points
Point
settings
Simple point information Detailed point information