Furuno MFD12 - How to Follow a Route Selected from the Routes List; How to Start Navigation from a Point

5. Routes
5-10
5.9.2 How to Follow a Route Selected from the Routes List
1. Press the MENU key to open the menu.
2. Open the [Routes-Routes] menu.
3. Use the RotoKey to select a route then push the key to show the Routes pop-up
menu.
4. [Go To] is selected. Push the RotoKey.
A red dashed line runs between current position and the point. This line is the course
to follow to get to the point. The point arrival area is indicated with a circle, or both cir-
cle and line. You can select the arrival area indication method with [Waypoint Switch-
ing Mode] in the [Routes-General] menu. To receive an aural alarm when you are
within a preset distance, turn on [Waypoint Notification] and set [Switching Circle Ra-
dius] on the [Routes-General] menu. The XTE alarm lines, red for port side, green for
starboard side, show the XTE alarm range. You can show or hide these lines with
[XTE Alarm Lines] in the [Routes-General] menu.
5.9.3 How to Start Navigation from a Point
1. Place the cursor on the point of the route from where to start navigation.
2. Push the right-click button to show the pop-up menu.
3. Select [Activate Rte from this Point] and push the RotoKey.
A red line runs between current position and the point. This line is the course to follow
to get to the point. The point arrival area is indicated with a circle, or both circle and
line. You can select the arrival area indication method with [Waypoint Switching Mode]
in the [Routes-General] menu. To receive an aural alarm when you are within a preset
distance, turn on [Waypoint Notification] and set [Switching Circle Radius] on the
[Routes-General] menu. The XTE alarm lines, red for port side, green for starboard
side, show the XTE alarm range. You can show or hide these lines with [XTE Alarm
Lines] in the [Routes-General] menu.
Skip
Activate Rte from this point
Delete