Furuno MFD12 - How to Set the Rotokey

13. How to Adjust Settings
13-6
13.1.2 How to Set the RotoKey
If the Basic, Standard or Full sets of soft controls are not acceptable, you can select
the soft controls to use on the [My NavNet] menu. To use your selections, set RotoKey
in the [My NavNet-General] menu to [Custom].
1. Press the MENU key to open the menu.
2. Open the My [NavNet-General] menu.
3. Open the [Chart], [Radar], [Fish Finder] or [Instruments] sub menu. For example,
open the [Radar] sub menu.
4. Use the RotoKey to select a soft control. Push the key to activate or deactivate
the soft control.
5. Press the MENU key to close the menu.