Furuno MFD12 - How to Extend a Route; How to Split a Route

5. Routes
5-4
5.2.4 How to Extend a Route
You can extend a route from the last point on the route.
1. Place the cursor on a leg of the route.
2. Push the right-click button to show the pop-up menu.
3. Use the RotoKey to select [Extend Route]. A dashed line runs from the last point
to the cursor.
4. Use the cursor to select a location then push the left-click button.
5. Repeat step 4 to enter more points, if necessary.
6. Push the RotoKey to finish.
5.2.5 How to Split a Route
You can divide a route in two to make two routes.
1. Put the cursor on the route leg where to divide the route.
2. Right-click to show the Routes pop-up menu.
3. Rotate the RotoKey to select [Split] then push the key.
When you divide a route, the new route is given the next route number. For example,
you can divide route 001 (see below) to make a new route, route 002.
Split
route
Route 001
Route 001
Split route here
Route 002