Furuno MFD12 - Stop Following a Route; Skip a Leg on a Route

5. Routes
5-13
5.10.3 Stop Following a Route
1. Use the CursorPad to put the cursor on the dashed line of the route.
2. Push the right-click button to show the Route Follow pop-up menu.
3. Use the RotoKey to select [Cancel Route].
The arrival area, XTE alarm lines and set course are erased from the screen. The red
lines turn blue.
5.10.4 Skip a Leg on a Route
There are times when you do not need to follow all legs in an active route. You can
skip a leg as shown in the procedure below. After you select the point to skip, the route
is re-drawn, with that point removed.
1. Put the cursor on the route point to skip.
2. Push the right-click button to show the Routes pop-up menu.
3. Use the RotoKey to select [Skip].
Restart
Reverse
Extend Route
Route Info
Skip this leg
Skip leg