Furuno MFD12 - Route Auto Zoom; XTE Alarm Lines

5. Routes
5-15
5.10.6 Route Auto Zoom
You can get automatic range change after you have moved past a route point. Use
this feature to find the next point in a route when the point is not within the current dis-
play range.
1. Press the MENU key to open the menu.
2. Open the [Routes-General] menu.
3. Use the RotoKey to select [Route Auto Zoom] then push the key to activate or
deactivate the zoom.
4. Press the MENU key to close the menu.
5.10.7 XTE Alarm Lines
The XTE alarm lines mark the XTE alarm range set on the [Alarm] menu. You can
show or hide these lines.
1. Press the MENU key to open the menu.
2. Open the [Routes-General] menu.
3. Use the RotoKey to select [Display XTE Alarm Lines] then push the key to show
or hide the lines.
4. Press the MENU key to close the menu.
XTE alarm lines