How to fix Furuno Monitor if it will not turn on?
If your Furuno Monitor won't turn on, check the following: * Inspect the fuse for any damage. * Ensure the power connector is securely fastened. * Look for corrosion on the power cable connector. * Check the power cable for any damage. * Verify the battery provides the correct voltage output (10.8 to 31.2 V).
Why do marks and characters appear but no picture on Furuno Monitor?
If marks and characters appear on the Furuno Monitor, but no picture appears, check that the transducer cable is connected.
Why is there no picture on Furuno Monitor after selecting fish finder display?
If you select a fish finder display with the DISP key on your Furuno Monitor, but no picture appears, check the following: * Ensure the signal cable for the fish finder is fastened. * Verify that the fish finder source is correct. * Confirm that the network fish finder is properly connected.
What to do if radar picture doesn't change after changing range on Furuno Monitor?
If you change the range on your Furuno Monitor, but the radar picture does not change, try hitting the RANGE keys again. If that doesn't work, turn the display unit off and on.
How to turn on vessel track on Furuno Monitor?
If the track of your vessel is not being plotted on the Furuno Monitor, check that the track is turned on. To do this, put the cursor on the boat icon to open the pop-up menu and check that "Tracks" is on.
Why do marks and legends appear but no echoes on Furuno Monitor?
If marks and legends appear on your Furuno Monitor, but echoes do not, check that the antenna cable is securely fastened.
How to fix the 'position not fixed' error on Furuno Monitor?
If the position is not fixed on your Furuno Monitor, check that the antenna connector is fastened and the navigator is correctly connected.
Why is the picture not updating or freezing on my Furuno Monitor?
If the picture on your Furuno Monitor is not updating or freezes, check the antenna cable. If the picture freezes, try turning the display unit off and on.
What to do if nothing appears on Furuno Monitor display after pressing power and GAIN/TX key?
If nothing appears on the Furuno Monitor display after pressing the power switch and then the GAIN/TX key, ensure you press the key for more than one second. Also, check that the antenna cable is securely fastened and that the radar source is correct.
General| Display Size | 12.1 inches |
|---|---|
| Brightness | 1000 cd/m² |
| Touchscreen | Yes |
| Power Supply | 12-24 V DC |
| Operating Temperature Range | -15°C to +55°C |
| Input Voltage | 12-24 V DC |
| Display Type | LCD |
| Resolution | 800 x 600 |
| Storage Temperature | -20°C to +70°C |
To Next Page
