1. OPERATION
1-22
1.8 Resetting Indications to Zero
You may individually reset the trip, odometer and graph indications to zero as
follows:
1. Press the [MENU] key once or twice to display the main menu.
2. Select RESET and then press the [ENT] key.
RESET
ALL BACKUP DATA?
TRIP?
ODOMETER?
GRAPH?
Reset menu
3. Select TRIP, ODOMETER or GRAPH as appropriate and then press the
[ENT] key. One of the following displays appears depending on your
selection.
RESET TRIP?
ARE YOU SURE?
YES NO
RESET ODOMETER?
ARE YOU SURE?
YES NO
ALL?
USER DISP1?
USER DISP2?
USER DISP3?
USER DISP4?
USER DISP5?
Windows for resetting trip, odometer and graph displays
4. For TRIP and ODOMETER, press ◄ to select YES and then press the [ENT]
key.
For GRAPH, select specific display number (USER DISP1-USER DISP5) or
ALL (resets all graphs) as appropriate and then press the [ENT] key. The
display shown below appears. Press ◄ to select YES and then press the
[ENT] key.
ERASE GRAPH DATA
ARE YOU SURE?
YES NO
Reset graph prompt
5. Press the [MENU] key twice to close the menu.
Note: For “ALL BACKUP DATA?” see page 2-4.
To Next Page
Loading...
