1. MOUNTING
7
1.3 Mounting Procedure
"Bird-repellent fixtures" (option) can be attached to the sensor cover to prevent birds from alighting
on the cover. If it is more convenient to attach them before mounting the sensor, do step 7 first.
1. As shown in the figure below, weld a platform (local supply) for which to mount the sensor.
The thickness of the platform should be max. 10 mm.
2. Open the cable cover on the underside of the sensor.
Hex. Bolt
M10x25: Thickness t=less than 5 mm
M10x30: 5<t<10 mm
Spring Washer
160
300
160
200
Fixing Hole
(
φ
11 mm)
BOW
Max. 10 mm
10
Cable entry (
φ
25
)
Flat Washer
Cable cover
To Next Page
Loading...
