What to do if the Furuno SCX-20 heading data is incorrect?
If the heading data on your Furuno Compass screen is incorrect, verify that the antenna location is proper. Compare the incorrect item with other equipment visually. Adjust the offsets as necessary.
Why is Furuno Compass not receiving data from the SCX-20?
The Furuno Compass might not be receiving data from the SCX-20 due to several reasons: * The SCX-20 cable connectors may not be firmly connected, the cable might be damaged or severed. Check the cable and its connections.* The CAN bus may not be powered or functioning normally. If the issue persists, it may also be due to incorrect settings at the display. Refer to the Multi-Function Display unit’s manual and adjust the settings as required.
General| Type | Satellite Compass |
|---|---|
| Operating Temperature | -15°C to +55°C |
| GPS | Yes |
| Update Rate | 10 Hz |
| Storage Temperature | -30°C to +70°C |
| Vibration | IEC 60945 |
| Shock | IEC 60945 |
| Accuracy | 0.5° |
| Heading Accuracy | 0.5° |
| Roll and Pitch Accuracy | 0.5° |
| Interfaces | NMEA0183, NMEA2000 |
| Humidity | 95% RH (non-condensing) |
To Next Page
