1. INSTALLATION
1-11
1.5.1 Installation notices
• Do not install the unit on an uneven surface.
• DO NOT apply the adhesive to the four vent holes near the name plate.
1.5.2 Required tools
The following tools should be prepared in advance for this installation.
1.5.3 How to mount the Antenna Unit
1. Attach the pole mount kit to the antenna base referring to subsection 1.3.3.
Note: The pipe included in the pole mount kit is not used.
2. Set the antenna base to the mounting location considering the tilt direction, and
make four mounting holes (4.2 to 5 mm) on the mounting platform.
Note: The possible tilt direction of the antenna base depends on the setting posi-
tion of the antenna base.
3. Make an antenna cable hole (25±2 mm) at the
center of the four mounting holes for passing
the supplied NMEA 2000 antenna cable
through the mounting platform.
Name Remarks
Electrical Drill For making the mounting holes
Drill Bit 4.2 to 5
Hole Saw For making the cable hole (25 mm)
File For smoothing the cut edge of the cable hole
Phillips-head Screwdriver #2
Bottom view of the antenna unit
Vent hole (four places)
Note:
Do not apply the
adhesive here.
Vent hole (four places)
Note:
Do not apply the
adhesive here.
Name plateName plate
Bow mark
Platform
Make mounting
holes (4 places).
Right Angle
Mounting Base
To Next Page
Loading...
