Furuno SCX-20 - Pole Mount; Installation Notices

1. INSTALLATION
1-4
7. Fasten the antenna unit to the mounting location with the three sets of supplied
upset screws (M520, flat and spring washers attached) from the bottom through
the mounting holes at step 2. After fastening the screws, coat the screw heads
with the supplied adhesive.
Note: Screw length is dependent on the thickness of the mounting platform.
1.3 Pole Mount
Combine the antenna unit with the pole mount kit then attach the antenna unit assem-
bly to the mounting pole.
1.3.1 Installation notices
• The diameter of the mounting pole must be 25 to 50 mm.
• Use the supplied pole mount kit and the supplied fixing support fixture for the pole
mount installation so that the bow mark of the antenna unit faces to the bow.
• Select the correct clamp size of the pole mount kit fixture considering the diameter
of the mounting pole.
Name Mast diameter Remarks
Hose Clamp For 20A to 25A (25 to 35 mm)
Standard supply with CP20-04603
For 32A to 40A (35 to 50 mm) Optional supply (OP20-52).
M5 upset screw,
w/flat and spring
washers
(3 places)
2 to 10 mm
20 mm
(supplied)
thickness + 8
to 16 mm
(local supply)
Otherwise
Thickness
(mounting plate)
Length of
M5 screw
Adhesive
Antenna cable
Antenna unit
Pole Mount
Assembly
Mounting
pole
Mounting
pole
Fixing Support
Fixture
Hose Clamp
Anchor point