18
Note 1: You may cancel repeated transmission from either operating mode by pushing the
button OFF→ON→OFF→ON→OFF. You must allow no more than three seconds
to elapse before pushing the button again. If more than three seconds elapses,
repeat the procedure. When transmission is stopped, the message “INF: SSAS
UNIT activation has been cancelled.” appears and, on the FELCOM 16 only, the
POWER lamp on the communication unit flashes approx. 30 seconds.
Note 2: Repeated transmission cannot be cancelled by turning off the unit. The unit
resumes repeated transmission when powered again.
To Next Page
Loading...
