1. OPERATION
1-4
1.3 Adjusting Panel Dimmer and Contrast
The panel dimmer and display contrast may be adjusted as follows:
1. Press the DIM key to show the dimmer and contrast setting screen.
DIMMER (0~8)
CONTRAST (0~63)
EXIT: [ENT]
4
44
2. Use ▲ or ▼ to adjust the panel dimmer; ◄ or ► to adjust the contrast.
(The default dimmer and contrast settings are 4 and 45, respectively. To
restore default settings see section 3.9 Restoring Default Settings.)
3. Press the ENT key to close the setting screen.
Note: If the equipment is turned off with the contrast setting of 35 or lower, the
equipment will start up with the contrast setting 36 when the power is again
turned on.
To Next Page
Loading...
