1. OPERATION
1-9
6. Press ► to show the ARRIVAL TIME sub-menu.
[ARRIVAL TIME]
DATE
[UTC]: 25/APR
TIME[UTC]: 0:00
7. DATE[UTC] is selected; press the ENT key.
8. Enter the date of arrival then press the ENT key.
9. TIME[UTC] is selected; press the ENT key.
10. Enter the estimated time of arrival, in 24-hour notation, then press the ENT
key.
11. Press ► to show the CARGO TYPE sub-menu.
[CARGO TYPE]
TYPE NO.: 00
**** TYPE DETAIL****
NOT AVAILABLE
12. TYPE NO. is selected; press the ENT key.
13. Select type of vessel/cargo, referring to the table on the next page, then
press the ENT key.
Note 1: Only the second digit for the type of vessel is entered here; the first
digit is entered on the INITIAL SETTINGS menu, during installation.
Note 2: When “Tanker” is selected and the Nav status is “Moored”, output
power is automatically switched to 1 W when SOG is less than 3 knots.
Further, in the above condition, when SOG becomes higher than 3 knots,
the pop-up message “CHANGE NAV STATUS?” appears and a beep
sounds. (The pop-up message “TX POWER CHANGED” also appears to
notify you that the Tx power has changed). To erase the pop-up message,
press any key or lower SOG below 3 knots.
To Next Page
Loading...
