1. OPERATION
1-28
5. To view the contents of a message, select the message then press the ENT
key. Below is an example of a received message.
QUIT[MENU]
[RX ADDRESSED MSG]*
I HAVE CHANGED MY
COURSE TO 350 DEGREE.
*RX BROADCAST MSG for
received broadcast message
6. Press the DISP key to close the log.
Automatically displaying incoming messages
You can display incoming messages automatically as follows:
1. Press the MENU key to open the menu.
2. Select USER SETTINGS then press the ENT key.
[USER SETTINGS]
KEY BEEP : ON
ALARM BUZZER : ON
AUTO SORT : ON
DISP SART TEST : ON
LR MODE : AUTO
RECEIVED MSG
CPA/TCPA ALARM
3. Select RECEIVED MSG, then press the ENT key.
[RECEIVED MSG]
POPUP : ALL
BUZZER : ON
4. Select POPUP, then press the ENT key
5. Select which category of receive message to
display automatically then press the ENT key.
ALL: Display any message upon receipt.
ABM: Display only addressed binary messages, upon their receipt.
OFF: Disable automatic displaying of incoming messages.
6. To get an audio alert when the message type selected at step 5 is received,
set "BUZZER" to ON.
7. Press the DISP key to close the menu.
ALL
ABM
OFF
To Next Page
Loading...
