Furuno UAIS TRANPONDER FA-150 - Page 43

1. OPERATION
1-32
5. Press the ENT key to show details.
[EDIT CHANNEL] 1/2
FROM MMSI: _ _ _ _ _ _ _ _ _
POWER : 12.5W
CH NO. CH-A: 2087
CH-B: 2088
MODE CH-A: TX/RX
CH-B: TX/RX
ZONE: 1NM
6. POWER is selected; press the ENT key to show the channel power
options.
1W
12.5W
7. Select power desired then press the ENT key.
8. CH NO. CH-A is selected; press the ENT key.
9. Select channel number for CH-A then press the ENT key.
10. CH NO. CH-B is selected; press the ENT key.
11. Select channel number for CH-B then press the ENT key.
12. MODE CH-A is selected; press the ENT key.
TX/RX
RX
UNUSED
13. Select desired mode for CH-A then press the ENT key.
Mode 1 2 3 4 5 6
CH-A TX/RX TX/RX RX RX RX UNUSED
CH-B TX/RX RX TX/RX RX UNUSED RX
14. MODE CH-B is selected; press the ENT key.
15. Select desired mode for CH-B then press the ENT key.
16. ZONE is selected; press the ENT key.
17. Key in the zone distance then press the ENT key. (The setting range is 1 to
8 (nm)).
18. Use ▼ or ▲ to show page 2 of the [EDIT CHANNEL] sub-menu.
[EDIT CHANNEL] 2/2
CH AREA
RIGHT TOP
LAT: 0
° 00.0'N
LON: 0
° 00.0'E
LEFT BOTTOM
LAT: 0
° 00.0'N
LON: 0
° 00.0'E
19. LAT of RIGHT TOP is selected; press the ENT key. Enter latitude for the
right-top position (northeast point) of the AIS operating area then press the
ENT key.