FUTABA 10CAG - Page 32

32
MODEL NAME
: assigns a name to the current model memory. By giving each model a name that is immediately recognizable,
\RXFDQTXLFNO\VHOHFWWKHFRUUHFWPRGHODQGPLQLPL]HWKHFKDQFHRIÀ\LQJWKHZURQJPRGHOPHPRU\ZKLFKFRXOGOHDGWR
a crash.
Adjustability and values:
• Up to 10 characters long.
• Each character may be a letter, number, blank, or a symbol.
• The default names assigned by the factory are in MODEL-xxxx format
(
MODEL-0001
IRU¿UVWPRGHOPHPRU\HWF
NOTE: When you
COPY
one model memory over another, everything is copied, including the model's name. Similarly, if
you change
MODEL TYPE
or do a
MODEL RESET
, the entire memory is reset, including
MODEL NAME
6RWKH¿UVWWKLQJ\RXZLOO
want to do after you
COPY
a model, change its type, or start from scratch, is rename the new copy to avoid confusion.
GOAL of EXAMPLE: STEPS: INPUTS:
Name model 3 “Cap-232_” (where the
underline represents a blank space.)
Open
MODEL
submenu.
for 1 second.
(If
ADVANCE
, again.)
C
to
MODEL
.
Confirm you are currently using the
proper model memory. (Ex: 3)
If
SELECT
does not indicate
3
,
perform
MODEL SELECT
, p. 25.
Go to
NAME
and change the first
character. (Ex: M to C)
C
to
M
to
C
.
Choose the next character to change.
C
Repeat the prior steps to complete
naming the model.
to
a
(note: lower case is available)
Repeat.
Close.
Where next? Change the
MODEL TYPE
to glider or helicopter: see p. 34.
Change modulation [
2.4G-10CH
or
2.4G-7CH
]: see p. 35.
Utilize servo
REVERSE
: see p. 38.
Adjust servo travel with
END POINT
: see p. 39.
6HWXSGXDOWULSOHUDWHVDQGH[SRQHQWLDO
D/R
,
EXP
): see p. 42.