FUTABA 10CAG User Manual

64
GOAL of EXAMPLE: STEPS: INPUTS:
Activate
AIRBRAKE
on a
FLAPERON
.
model. Adjust the flaperon travel to
75%
,with negative elevator (push) of
25%
.
&RQ¿UP
FLAPERON
is active. see
FLAPERON
instructions.
Open the
AIRBRAKE
function.
for 1 second.
(If
BASIC
, again.)
C
to
AIRBRAKE
.
Activate the function.
Switch C in up position.
C
to
MIX
. to
OFF
.
Adjust the travels as needed.
(Ex:Ailerons each
75%
, Elevator
-25%
.)
C
to
AIL1
. to
75%
.
C
to
ELEV
. to
-25%
.
C
to
AIL2
. to
75%
.
Optional: delay how quickly the
elevator servo responds.
C
to delay-
ELEV
. to
25%
.
Optional: change the mixing from full
amount upon switch to proportional to
the THROTTLE STICK's proximity to
idle.
C
to
MODE
.to
Linear
(
0%
).
THROTTLE STICK to desired
0
point.
for 1 sec, until beeps
(display changes if new setting is different from prior
setting).
Close menu.
Where next? $GMXVWÀDSHURQVWRWDOÀDSWUDYHODYDLODEOH
FLAPERON
): see p. 52.
Set up
ELEV-FLAP
mixing: see p. 62.
Set up programmable mixes, for example,
FLAP-ELEVATOR
: see p. 67.
View additional model setups on the internet: www.futaba-rc.com\faq\.
• Twin elevator servos:
•If
AILEVATOR
is active, the
AIL1
and
AIL2
settings still only affect
FLAPERON
or
AIL-DIFF
servos, NOT the elevator servos.
(they would have the
AIL3
and
AIL4
settings.)

FUTABA 10CAG Specifications

General

Brand	FUTABA
Model	10CAG
Category	Remote Control
Language	English