FUTABA 10CAP - MODEL NAME

32
MODEL NAME
: assigns a name to the current model memory. By giving each model a name that is immediately recognizable,
\RXFDQTXLFNO\VHOHFWWKHFRUUHFWPRGHODQGPLQLPL]HWKHFKDQFHRIÀ\LQJWKHZURQJPRGHOPHPRU\ZKLFKFRXOGOHDGWR
a crash.
Adjustability and values:
• Up to 10 characters long.
• Each character may be a letter, number, blank, or a symbol.
• The default names assigned by the factory are in MODEL-xxxx format
(
MODEL-0001
IRU¿UVWPRGHOPHPRU\HWF
NOTE: When you
COPY
one model memory over another, everything is copied, including the model's name. Similarly, if
you change
MODEL TYPE
or do a
MODEL RESET
, the entire memory is reset, including
MODEL NAME
6RWKH¿UVWWKLQJ\RXZLOO
want to do after you
COPY
a model, change its type, or start from scratch, is rename the new copy to avoid confusion.
If using multiple frequency modules to be able to transmit on multiple channels, we recommend using the last 2 characters
to indicate the receiver's channel for clarity. For more information on frequency transmission, see p. 8.
GOAL of EXAMPLE: STEPS: INPUTS:
Name model 3 “Cap-232_” (where the
underline represents a blank space.)
Open
MODEL
submenu.
for 1 second.
(If
ADVANCE
, again.)
C
to
MODEL
.
Confirm you are currently using the
proper model memory. (Ex: 3)
If
SELECT
does not indicate
3
,
perform
MODEL SELECT
, p. 25.
Go to
NAME
and change the first
character. (Ex: M to C)
C
to
M
to
C
.
Choose the next character to change.
C
Repeat the prior steps to complete
naming the model.
to
a
(note: lower case is available)
Repeat.
Close.
Where next? Change the
MODEL TYPE
to glider or helicopter: see p. 34.
Change modulation [FM (
PPM

PCM
or
2.4G-10CH

7CH
]: see p. 35.
Utilize servo
REVERSE
: see p. 38.
Adjust servo travel with
END POINT
: see p. 39.
6HWXSGXDOWULSOHUDWHVDQGH[SRQHQWLDO
D/R
,
EXP
): see p. 42.