13
Before Using
- Digital trim: Steering trim, Throttle trim, Steering D/R
The current position is displayed on the LCD screen for about three seconds when
each digital trim is operated.
- Function select lever function (FNC-DT1/DT2/DT3/DT4)
This function assigns a function to levers (digital trims, grip levers). Trim positioning
at each model call is unnecessary because all the levers are digital.
- Function select switch function (FNC-SW1/SW2)
This function assigns a function to the two installed switches.
- Condition 2 Selection (COND2)
In specific functions, two rates can be set up, and switched with SW1 switch simulta-
neously during a run.
- NEW design considers operability and weight balance
- Stick Lever Head Adjustment
- High luminosity blue LED pilot lamp (LED-MD)
You can select your desired brightness of the pilot lamp. (Four steps)
- Throttle Neutral Adjuster (THR-NT)
You can select your desired throttle neutral position. (7:3 or 5:5)
To Next Page
Loading...
