❏ 1. Remove the antenna end cap and gently pull the antenna
tube from the antenna mount on top of the receiver housing.
Be careful not to damage the receiver antenna wire.
❏ 2. Remove the three body clips from the receiver box cover
and remove the receiver cover from the chassis.
❏ 3.
Disconnect the battery plug and three servo plugs from
the stock receiver. Hint: This would be a good time to
mark each servo connector so that you know what
servo it controls (i.e. steering servo is #1, throttle servo
is #2). Remove the receiver from the receiver mount. Clean
off any excess servo tape left behind on the receiver mount.
Hint: Use lighter fluid to clean the excess servo tape
and adhesive from the receiver mount.
❏
4. Install the Futaba R303FS receiver onto the receiver
mount using new (not included) double sided tape.
❏
5. Plug the receiver battery connector into the slot on the
receiver marked “B/C.”
❏
6. Plug the steering servo connector into the slot on the
receiver marked channel 1.
❏
7. Plug the throttle servo connector into the slot on the
receiver marked channel 2.
INSTALL THE RECEIVER
Installing and Setting Up the Futaba
®
3PM in the HPI Savage
Before installing the radio system, read the Futaba 3PM instruction manual completely.
To Next Page
Need help?
General
