FUTABA CGY750 - Page 75

G
OVERNOR
B
ASIC
S
ETTING
75
(7) Battery failsafe setting [default: Inhibit]
The governor goes into the failsafe mode when
the battery voltage is below BFS.Volt. When
activated, the governor is deactivated and the
throttle servo is moved to B/FS position. Move
the throttle stick to idle position. The B/FS
CONDITIONISDEACTIVATEDFORSECONDSANDRE-
TURNEDTO"&3AFTERSECONDSHAVEPASSED
Move the throttle stick to B/FS position as de-
sired. Push set key to confirm the setting. Push-
ING23%4WILLINHIBITTHEFUNCTION
(8) Yaw rate compensation [default: CW/
TOP]
This works the revolution compensation dur-
ing pirouette. Set the mode to match the gyro
installing direction, either CW/TOP, CW/BOTM,
CCW/TOP, CCW/BOTM by pushing the Set key.
0USHINGTHE23%4KEYINHIBITSTHEFUNCTION
At the governor only mode, this function is in-
hibited.
CW: clockwise
CCW: counter clockwise
TOP: normal side
BOTM: reverse side