38
DATA SETTING
Setting of Each Function
Initial screen at power on
This is the initial screen at power on. When the transmitter power is
off, "*IDLE**" is displayed until the transmitter power is turned on.
After the transmitter power is turned on, "*INIT***" blinks for about
5 seconds to read the reference data. During this period, do not move
the transmitter rudder stick or the helicopter. If the transmitter rudder
stick or helicopter is moved by mistake, the rudder neutral position
will change.
Operation screen display / Power supply voltage display
Normal mode operation
Low battery alarm
Rudder neutral memorization updating
AVCS mode operation
Rudder neutral deviation display
To Next Page
Loading...
