FUTABA T26SZ - Page 100

100
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ŷƈƏƈƐƈƗƕƜŝŃŹƒƏƗƄƊƈŃŃžŨƛƗőŃƅƄƗƗƈƕƜƀ
ŤƏƄƕƐŃƖƈƗŃ
1. Tap Alarm and choose from Buzzer, Voice, and
Inhibit.
2. Choose "Inhibit" for Vibrator if not using the vibrator
alarm. If using vibrator, choose one of the three
types.
3. Tap Limit [4.0 V].
4. Adjust the rate using the
"▼▼""▼""▲""▲▲"
buttons.
Initial value: 4.0 V
 $GMXVWPHQWUDQJH9a9
*When the screen is tapped for one second, the rate is reset to
the initial value.
5. To terminate the input and return to the original
state, push the EXIT button.
Setsthevoltageon
whichthealarm
operates.
↓ The"down"arrowwill
indicatethatanalarm
willsoundwhenthe
voltagedropstobelow
thesetting.
Alarmischosenfrom
Buzzer,Voice,and
Inhibit.
AllowsSpeechtobe
turnedONorOFF.
●
Tap the [Voltage] button in the Telemetry screen to call
the setup screen shown below.
Max.andmin.values
sincethepowerwas
turnedONwilldisplay.
Type1
Type2
Type3
"Vibrator"type
Ifthefollowingtypesareselected,thetransmitter
willvibrateduringthewarning.
Displaying data from the EXT battery
voltage port
In this screen, the EXT battery voltage is
displayed.
In order to use this function, it is
necessary to connect External voltage connector of
R7208SB (R7308SB)
⇔
SBS-01V
⇔
Battery
SBS-01V measures two batteries. The power
battery connected to two lines is displayed on EXT-
VOLT.
*SBS-01Vmustbeinstalledintheaircraft.
Ext.batteryvoltage
●
Return to Linkage
menu