FUTABA T26SZ - Page 102

102
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
*Positioning time of GPS
When powered up, the SBS-01/02G begins to
acquire GPS satellite data. This process can
take several minutes. Please do not move the
model during this process. During acquisition,
the LED on the SBS-01/02G will blink green;
after the satellite's signals have been acquired,
the LED will become solid green, and the GPS
signal strength display on the transmitter will
show three bars.
Moving the model before the satellites are fully
acquired will cause a delay in acquiring the
satellite signal.
ũƌƕƖƗŏŃƗƋƈŃƖƈƗŃƒƉŃƄŃƕƈƉƈƕƈƑƆƈŃƌƖŃƕƈƔƘƌƕƈƇő
1. The model and transmitter to which the GPS sensor
was connected are turned on.
2. Tap to the [Preset] of "Reference" item.
*Now, the position of the present model was set to 0 m.
ŶƈƗƗƌƑƊŃƄŃŅƗƒƒŃƉƄƕŅŃƄƏƄƕƐŃƇƌƖƗƄƑƆƈŃ
1. Tap Alarm and choose from Buzzer, Voice, and
Inhibit.
2. Choose "Inhibit" for Vibrator if not using the vibrator
alarm. If using vibrator, choose one of the three
types.
3. Tap Limit [m].
4. Adjust the rate using the
"▼▼""▼""▲""▲▲"
buttons.
Initial value: 1,000 m
 $GMXVWPHQWUDQJHPaP
Ń/LPLW
≧
Ņ/LPLW
*When the screen is tapped for one second, the rate is reset to
the initial value.
5. To terminate the input and return to the original
state, push the EXIT button.
ŶƈƗƗƌƑƊŃƄŃŅƗƒƒŃƆƏƒƖƈŅŃƄƏƄƕƐŃƇƌƖƗƄƑƆƈ
1. Tap Alarm and choose from Buzzer, Voice, and
Inhibit.
2. Choose "Inhibit" for Vibrator if not using the vibrator
alarm. If using vibrator, choose one of the three
types.
3. Tap Limit [m].
4. Adjust the rate using the
"▼▼""▼""▲""▲▲"
buttons.
Initial value: 0 m
 $GMXVWPHQWUDQJHPaP
Ń/LPLW
≧
Ņ/LPLW
*When the screen is tapped for one second, the rate is reset to
the initial value.
5. To terminate the input and return to the original
state, push the EXIT button.
ŧƌƖƗƄƑƆƈ
Telemetry
Data