FUTABA T26SZ - Page 108

108
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ŷƈƏƈƐƈƗƕƜŃŝŃŤƌƕƖƓƈƈƇŃƖƈƑƖƒƕŃžŤƌƕƖƓƈƈƇƀ
Displaying data from the
airspeed
The speed screen displays and sets the speed
data from an SBS-01TAS (Airspeed sensor) sold
separately.
The speed of the aircraft during flight can be
GLVSOD\HG$IWHUÀLJKWWKHPD[LPXPVSHHGGXULQJ
flight can be viewed. Airspeed is the speed of an
aircraft relative to the air. You will be able to get a
more accurate aircraft speed.
*Airspeedsensormustbeinstalledintheaircraft.
ŤƏƄƕƐŃƖƈƗƗƌƑƊŃƚƋƈƑŃƖƓƈƈƇŃƌƑƆƕƈƄƖƈƖŃ
1. Tap Alarm and choose from Buzzer, Voice, and
Inhibit.
2. Choose "Inhibit" for Vibrator if not using the vibrator
alarm. If using vibrator, choose one of the three
types.
3. Tap Limit [xxx km/h].
4. Adjust the rate using the
"▼▼""▼""▲""▲▲"
buttons.
 $GMXVWPHQWUDQJHNPKaNPK
Ń/LPLW
≧
Ņ/LPLW
*When the screen is tapped for one second, the rate is reset
to the initial value.
5. To terminate the input and return to the original
state, push the EXIT button.
Setsthespeedon
whichthealarm
operates.
●
Tap the [Speed sensor] button in the Telemetry screen to
call the setup screen shown below.
Max.andmin.values
sincethepowerwas
turnedONwilldisplay.
Speed
Alarmischosenfrom
Buzzer,Voice,and
Inhibit.
AllowsSpeechtobe
turnedONorOFF.
*The Airspeed sensor is necessary, and is sold separately.
Mount and connect the sensor in accordance with the sensor
instruction manual.
↑Anupwardarrow
indicatesthealarmwill
soundwhenthespeed
reachesaboveyourset
value.
↓Adownwardarrow
indicatesthealarmwill
soundwhenthespeed
reachesbelowyourset
value.
●
Return to Linkage
menu
Type1
Type2
Type3
Ifthefollowingtypesareselected,thetransmitter
willvibrateduringthewarning.