FUTABA T26SZ - Page 113

113
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
Telemetrydatalogfunction
TelemetrydatahasbeenadaptedtothelogfunctionwhichisrecordedatthemicroSDcard.
【Settingmethod】
① OpenthelinkagemenuTele.settingscreen.
② Logrecordingcanbestartedandstoppedbyoperatingaswitch.TheLoggingswitchisselected.
③ Thelogoutputintervalcanbeset.
*ThedatatoberecordedisupdatedatthetimesetbyLinkagemenu → SystemTypescreenD/Linterval.For
example,whenthelogoutputintervalis1secondandtheD/Lintervalis2secondsthesamedataisoverlapped
andrecordedtwice.
【Operationmethod】
① InsertthemicroSDcardintothecardslot.
② SettheswitchsetbyLogStart/StopSwitchtoON.Abeepsoundsandalogfileiscreatedandrecordingofthe
telemetrydatabegins.
AbsolutelyneverremovethemicroSDcardwhilelogdataisbeingrecorded.
③ SettheswitchsetbyLoggingswitchtoOFF.Abeepingsoundisgeneratedandrecordingofthetelemetrydata
stops.
④ TurnoffthetransmitterpowerandremovethemicroSDcard.
■Logfile
AlogfileiscreatedinthemicroSDcardLOGfolder.Twofileswiththesamefilename,butadifferentextensionare
created.(Example:00001234.FLI,00001234.FLD)
■ExtensionFLI:Slotallocationinformationfile
■ExtensionFLD:Logdatafile
*Whencopyingormovingalogfile,alwaysselectboththe.FLIfileand.FLDfile.
LogfilescanbeconvertedtoCSVformatbyusingthetelemetrylogconverteravailableattheFutabawebsite.
■Notes
◇ AltimeteraltitudedataandGPSdistanceandaltitudedataoutputwiththepointthattimeloggingstartedasthe
reference(0m).Whenthetransmitterpresetpositionandthelogstartpositionaredifferent,thetransmitterdisplay
andthelogdatadisplaywillalsobedifferent.Thealtitudeanddistancefromthetake-offpositioncanberecorded
bystartingloggingimmediatelyaftertake-off.
◇ Thetransmittergearratioornumberoffinssettingisnotreflectedinthespeedometerlogdata(speed).Multiply
thegearratioornumberoffinsbythespeeddata.
◇ WhenthemicroSDcardbecomesfull,recordingstopsanddoesnotresumeevenifloggingisrestarted.
ŷƈƏƈőŃƖƈƗƗƌƑƊŃ
●
Tap the [Tele.setting] button in the Linkage menu to call
the setup screen shown below.
Speech interval set , data logging of telemetry.
Set the speech interval of telemetry data, and the
logging of telemetry data to a microSD card at
chosen intervals.
Telemetry data can be checked on your PC after a
ÀLJKW
Setsthespeechinterval
Initialvalue:0sec.
Adjustmentrange0-30sec.
●
Return to
Linkage menu