FUTABA T26SZ - Page 115

115
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ŷƕƄƌƑƈƕ
Trainer system starting and setting
T26SZ trainer system makes it possible for the
instructor to choose which channels and operation
modes can be used in the student's transmitter.
The function and rate of each channel can be set.
The training method can also be matched to the
student's skill level. Two transmitters must be
connected by an optional Trainer Cord, and the
Instructor's transmitter should be programmed for
trainer operation, as described below.
When the Instructor activates the trainer switch, the
student has control of the aircraft (if MIX/ FUNC/
NORM mode is turned on, the Instructor can make
corrections while the student has control). When
the switch is released the Instructor regains control.
This is very useful if the student gets the aircraft
into an undesirable situation.
●
Setting data are stored to model data.
●
Student rate can be adjusted at MIX/FUNC/NORM
mode.
●
Activated student channels can be selected by
switches.
1RWH This trainer system can be used in the following
manner:
1. With the T26SZ transmitter and a conventional
transmitter, if the channel order is different, it is
necessary to match the channel order before using this
function.
You can select the channel of input data from student's
transmitter in the "FUNC" or "MIX" mode.
2. When the T26SZ is used as the instructor’s transmitter,
set the modulation mode of the student’s transmitter to
PPM.
If being used as the student, T26SZ can be connected to
the instructor's transmitter which requires the student's
mode to be PPM. T26SZ always sends PPM mode signal
from the trainer jack.
(In the case of student's transmitters other than 2.4 GHz)
3. Be sure that all channels work correctly in both
WUDQVPLWWHUVEHIRUHÀ\LQJ
&RUUHVSRQGLQJW\SHVRIWUDQVPLWWHUVDQGWUDLQHUPRGHVHWWLQJV
Types of transmitters
,QVWUXFWRUVWUDQVPLWWHUVHWWLQJV 6WXGHQWVWUDQVPLWWHUVHWWLQJV
System Type Trainer setting System Type Trainer setting Trainer Cords
,QVWUXFWRU Student Mod. mode CH mode Mod. mode CH mode Mod. mode
76=);
76*7,=6
76=76=70=
70=
76=);
76*7,=6
76=76=70=
70=
Arbitrary 16CH Arbitrary 16CH 
T12FG and 9C
Trainer Cords
T26SZ
70=);7=
7)*
);
Arbitrary 12CH
3&0*
2.4G
12CH PPM
T26SZ 7)*); Arbitrary
12CH )$6670/7

&+ )$66708/7
T26SZ
7&7&
7&7(;7(;
Arbitrary &+ PPM  T12FG
T26SZ 7&*7& Arbitrary &+ Arbitrary  T12FG
T26SZ
7-7-7.7-
T6L
Arbitrary &+ Arbitrary 
T12FG and 9C
Trainer Cords
70=);7=
7)*
);
T26SZ Arbitrary 12CH Arbitrary 12CH 
7)*); T26SZ Arbitrary 12CH Arbitrary 12CH 
7&7&*7-
7&7&
7&7-7.
7-
T26SZ Arbitrary  Arbitrary &+ 
Wireless trainers are described on pages 36-37.