FUTABA T26SZ - Page 127

127
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ŤũŵŃ
The angle and curve of each operation function can be set. [All model types]
AFR function is used to adjust the throw and
operation curve of the stick, lever, and switch
IXQFWLRQVIRUHDFKÀLJKWFRQGLWLRQ
7KLVLVQRUPDOO\XVHGDIWHU(QG3RLQWKDVGH¿QHG
the maximum throw. When mixing is applied from
one channel to another channel, both channels
can be adjusted at the same time by adjusting the
operation rate through the AFR function.
●
Operation curve adjustment: Three types of
curves (EXP1, EXP2, and Point) can be selected.
A maximum 17 points curve can be used for the
point curve type. (Initial setting: 9 points) The
number of points can also be increased and
decreased and curves from complex curves to
simple curves can be used.
●
Operation speed adjustment: The operation speed
of each function when the function is operated
(including at flight condition switching) can be
adjusted. The function operates smoothly at a
constant speed corresponding to the set speed.
●
Select [AFR] at the model menu and call the
setup screen shown below.
)XQFWLRQVHOHFWLRQ
1. When the function select button is tapped, a selection screen appears.
2. Select the function you want to set at the selection screen.
WhenD/RisturnedON,thedisplaywillshow
"D/R----",andtherudderangle(rate)andEXP
canbesetwhenD/RisON.
● Operationcurvesetting
(Foradescriptionofthesettingmethod,seethe
descriptionatthebackofthismanual.)
● Servospeedsetting
(Foradescriptionofthesetting
method,seethedescriptionatthe
backofthismanual.)
● Group/singlemodeswitch(Gr./Sngl)
(Formoreinformation,seethedescription
atthebackofthismanual.)
●
Return to Model menu
Left/right,Up/down,overall
adjustmentatRateAandRate
B
Curveselect
Separately ⇔ Combination
(Leftandright
symmetrical
curve.)
Curveselect
EXP1,EXP2,Pointcurve
100%
40%
Rate
Rate