FUTABA T26SZ - Page 137

137
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
AIL
AIL
AIL3
(ChipAileron)
AIL4
(ChipAileron)
AIL1
(MainAileron)
AIL2
(MainAileron)
FLP2
(CamberFlap)
FLP1
(CamberFlap)
ŤŬů ڀ ŦƄƐƅƈƕŃƳƄƓ
[Corresponding model type]: Airplane/
JOLGHUDLOHURQVÁDSVRUPRUH
This mix operates the camber flaps (FLP1/2)
in the aileron mode. When the aileron stick
is manipulated, the ailerons and camber flaps
perform aileron operation simultaneously and
the operation characteristic of the roll axis is
improved.
ŏ7KHDLOHURQOHIWULJKWPL[LQJUDWHRIHDFKÁDSVHUYR
FDQEHÀQHWXQHG
ŏ$PL[LQJFXUYHFDQEHVHW
ŏ$Q212))VZLWFKFDQEHVHW
ŏ/LQNLQJLVSRVVLEOH/LQNWKLVPL[WRRWKHUPL[HV
Adjustmentofeach
flapservo
ŶƈƗƗƌƑƊŃƐƈƗƋƒƇ
●
Tap [INH].
(ON is displayed.)
●
When setting a switch, tap the [--] item of the
switch and tap the screen to call the selection
screen, and then select the switch and set its ON
direction. (Always ON at "--" setting)
(For a description of the switch selection method,
see the the back of this manual.)
●
7DSWKHOHIWRUULJKWLWHPRIHDFKÁDSVHUYR
Adjust the mixing rate.
*When the mixing direction is reversed by the linkage,
adjustments can be made by changing the mixing rate
polarity (+ or -).
●
A mixing curve can be set. (1/2 page)
(For a description of the mixing curve setting
method, see the description at the back of this
manual.)
●
To set linking, tap the [Link] item.
Set it to ON and tap the screen.
●
Select [AIL
→
Camber flap] at the
model menu and call the setup
screen shown below.
Currentlyselectedconditionname
● Mixingcurvesetting
(Foradescriptionofthe
settingmethod,seethe
descriptionatthebackof
thismanual.)
Left/rightoverall
adjustmentatRateA
andRateB
Activatethefunctionby
tappingthe[INH].
Conditiongroup/single
modeselection(Gr./Sngl)
TheON/OFFswitchof
mixingischosen.
Tosetlinking,taptothe
[OFF]item
●
Return to Model menu