FUTABA T26SZ - Page 136

136
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
FLP2
(CamberFlap)
FLP1
(CamberFlap)
FLP3
(BrakeFlap)
FLP4
(BrakeFlap)
ũƏƄƓŃƖƈƗƗƌƑƊ
[Corresponding model type]: Airplane/
JOLGHUÁDSVRUPRUH@
The up/down travel of each flap (camber flaps:
FLP1/2, brake flaps: FLP3/4) can be adjusted
independently at each servo according to the wing
type.
ŏ7KHRSHUDWLRQUHIHUHQFHSRLQWRIHDFKÁDSFDQEH
offset
The camber flaps of a 4-flap model can be mixed
ZLWKWKHEUDNHÀDSV%UDNH)/3WRFDPEHU)/3
ŏ$Q212))VZLWFKFDQEHVHW
ŶƈƗƗƌƑƊŃƐƈƗƋƒƇ
●
7DSIODS)/3aXSRUGRZQDFFRUGLQJWRWKH
wing type.
Adjust the travel independently.
●
To offset the operation reference point of each
ÁDSWDSWKHFRUUHVSRQGLQJRIIVHWLWHP8VHWKH
" ▼
▼ "" ▼ "" ▲ "" ▲▲ "
button to offset the reference
point.
●
When using brake FLP to camber FLP mixing,
tap the [INH] item and tap the screen. (ON is
displayed.)
When setting a switch, tap the [--] item of the
switch and tap the screen to call the selection
screen. Then, select the switch and set its ON
direction. (Always ON at "--" setting)
(For a description of the switch selection method,
see the description at the back of this manual.)
Camberflapsetting Brakeflapsetting
●
Select [Flap setting] at the model menu and call
the setup screen shown below.
*Thedisplayscreenisan
example.Theactualscreen
dependsontheModelType.
Conditiongroup/single
modeselection(Gr./Sngl)
(Formoreinformation,see
thedescriptionatthebackof
thismanual.)
Currentlyselectedconditionname
BrakeflaptoCamberflapsetting
Operationreference
pointoffset
Operationreference
pointoffset
Upside/Downside
adjustment
Upside/Downside
adjustment
TheON/OFFswitchof
mixingischosen.
Mixing
INH ⇔ ON
Operationisperformedviathevolumeswitches,
etc.,setforeachflapcontrolofthefunction.
Theoperationalvolume
switchissetupby"Function"
●
Return to Model menu