FUTABA T26SZ - Page 69

69
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ŏ7DSWKH>)XQFWLRQ@EXWWRQLQWKH/LQNDJHPHQXWRFDOO
the setup screen shown below.
ũƘƑƆƗƌƒƑ
Channel assignment for each function can be changed to suit your needs.
When you select model and wing (swash) types,
you will find that the optimized combinations of
servo output channels and functions have been
already preset. If you would like, on the function-
setting screen of the linkage menu, you can freely
change combinations of servo output channels,
functions (aileron, elevator, etc), and input
controllers (sticks, switches, trim levers and trim
switches). You can also assign the same function to
multiple servo output channels such as assigning
elevator function to CH2 and CH3.
ũƘƑƆƗƌƒƑŃƆƋƄƑƊƈ
1. Tap the function button of the channel you want
to change to call the Function select.
2. Select the function you want to change.
'*'*VZLWFKFKDQQHOV
These two channels can be used as switch (On/
2൵FKDQQHOV<RXFDQIUHHO\FKDQJHFRPELQDWLRQV
between servo output channels and input controllers
(sticks, switches, trim levers and trim switches).
&KDQQHOUHVWULFWLRQVE\D6\VWHP7\SH
FASSTest 26CH---24 CH+2 Switch
FASSTest 18CH---16 CH+2 Switch
FASSTest 12CH---10 CH+2 Switch
T-FHSS AIR ---16 CH+2 Switch
S-FHSS --- 8 CH
ŲƓƈƕƄƗƌƒƑŃƆƒƑƗƕƒƏŃƆƋƄƑƊƈ
1. Tap the control button of the channel you want
to change. A control select screen (stick, switch,
knob, trim lever, etc.) is displayed.
2. Select the control you want to operate.
*The same control can be assigned to multiple channels.
ŏ5HWXUQWR/LQNDJH
menu