FUTABA T26SZ - Page 70

70
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
TheMotorfunctionisusedwhenswitchingthemotor
ON/OFF(mostlyformotorgliders).FormostEPplanes,
thethrottlecanbeleftas-iswhencontrollingthemotor
bystick.Thismeansthatthevariousthrottle-related
functionsareusableviamotorcontrol.
Tapthechannelyou
wishtoreverse.
Tapthe “Yes”
→ H/Wreverse
ŷƕƌƐŃƆƋƄƑƊƈ
1. Tap the trim button to call the trim setup screen.
ūŒźŃƕƈƙƈƕƖƈ
2. The following items can be set at the trim setup
screen.
●
Hardware setting (Selection of switch, etc. which
controls trim)
●
Rate setting
●
Trim mode setting
Normal mode: Normal trim (linear) operation
ATL mode: ATL operation mode. (Works at only one
end of operation) Reverse is also possible.
Center mode: Maximum change near center by
center trim operation (Does not change at end of
the stick movement)
This function reverses the operation signal of the
sticks, switches, trim levers, and knobs.
Note: This setting reverses the actual operation
signal, but does not change the display of the
indicators on the display. Use the Normal mode as
long as there is no special reason to use the reverse
mode.