FUTABA T26SZ - Page 153

153
ڀ ŪŲŃƗƒŃŷŤťůŨŃŲũŃŦŲűŷŨűŷŶ
ŪƜƕƒ
[Corresponding model type]: Airplane/glider/multicopter, general
This function is used when a GYA Series gyro
is used to stabilize the aircraft's attitude. The
sensitivity and operation mode (Normal mode/GY
mode) can be switched with a switch.
ŏ7KUHHUDWHV5DWH5DWH5DWHFDQEH
switched.
ŏ8SWRD[HV*\UR*\UR*\URFDQEH
simultaneously controlled.
*Initial setting does not assign a sensitivity channel. Use the
Function menu of the Linkage menu to assign the sensitivity
channel (Gyro/Gyro2/Gyro3) used to a vacant channel
beforehand.
Set [Control] and [Trim] other than Function to [--].
ŏ7KUHHUDWHV5DWH5DWH5DWHFDQEHXVHG
Tap to the [Rate] item. Adjust the rate.
ŏ:KHQXVLQJWKLVIXQFWLRQ7DS>,1+@
ŏ:KHQD)XWDED*<$J\URLVXVHGZKHQ>*<@W\SHLVVHOHFWHGWKHVHQVLWLYLW\VHW
value is directly read in both the AVCS and Normal modes.
ŏ:KHQVHWWLQJDVZLWFKWDSWKH6ZLWFKLWHPDQGWDSWKHEXWWRQWRFDOOWKH
selection screen, and then select the switch and set its ON direction.
(For a description of the switch selection method, see the description at the end
of this manual.)
ŏ6HOHFW>*\UR@DWWKHPRGHOPHQXDQGFDOO
the setup screen shown below.
Theoperationmode
(AVCS/NOR)and
sensitivityofthe3axes
Gyro/Gyro2/Gyro3can
beset.
3rate(gyrogain)
adjustment
Conditiongroup/single
modeselection(Gr./
Sngl)
TheON/OFFswitchof
gyroischosen.
TappingthiswillchangeINHtoeitherONorOFF
andenableoperation.Adjustmentofthethreerates
(sensitivity)andswitchingbetweenNormalandAVCS
ispossible.
ŏ5HWXUQWR0RGHOPHQX